Otherwise, remove ONE screw securing the top of the dryer to the sides to give it a little vertical clearance on the drum and lift the drum out.

The top of the dryer will still be attached by the wiring harness but can be set aside far enough to get access for the next operation.

The back plate is now exposed. There 4 screws around the edges holding it in as well as two more in the upper right corner securing the dryer power cord terminal block and a ground wire.

There is also one connector going to the neutral on the power cord terminal block (make sure you reconnect it to neutral!).

After all these are disconnected the back plate will lift out.