Insert 2 x M3 Square Nuts in to their places on the Y Motor holder.

Use 2 x M3x40 Socket Cap Screws to assembly Y motor support to the motor holder.

Mount the motor to the holder with 3x M3x14 Socket Cap Screws

Push the GT2 16T pulley to the motor shaft and ensure that one of the tightening screws are landing on the flat surface of the motor shaft, tighten the 2x M2 hex pulley screws to fasten the pulley on the shaft.

Y Motor cable should be downwards.

Use the supplied Y motor alignment tool to position the motor.

Mount the Y Motor holder with a M6x14 Socket Cap Screw.