crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Tobias Isakeitcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tobias Isakeit

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] bar montage
[* black] Go on with positioning the handlebar centered in the stem clamp and put the faceplate back on.
[* black] Retighten the bolts of the faceplate while the bar is in a adequate position with slightly pointing down brake levers, until they hold the bar.
-[* black] Now tighten the bolts in a over cross pattern, starting with upper left going to lower right, then upper right going to lower left. The torque wrench value for this should be around ***8Nm***.
- [* icon_caution] Make sure the upper and lower clamping slots between faceplate and stem body are parallel and identical width.
+[* black] Now tighten the bolts in a cross pattern, starting with upper left going to lower right, then upper right going to lower left. The torque wrench value for this should be around ***8 Nm***.
+ [* icon_caution] Make sure the upper and lower gaps between faceplate and stem body are parallel and with an identical width.