crwdns2933803:03crwdne2933803:0
crwdns2933797:0Dominik Schnabelrauchcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Dominik Schnabelrauch
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] bar montage | |
| - | [* black] insert bar |
| - | [* black] put front of stern back |
| - | [* black] tighten screws |
| + | [* black] Go on with positioning the handlebar centered in the stem clamp and put the faceplate back on. |
| + | [* black] Retighten the bolts of the faceplate while the bar is in a adequate position with slightly pointing down brake levers, until they hold the bar. |
| + | [* black] Now tighten the bolts in a over cross pattern, starting with upper left going to lower right, then upper right going to lower left. The torque wrench value for this should be around ***8Nm***. |
| + | [* icon_caution] Make sure the upper and lower clamping slots between faceplate and stem body are parallel and identical width. |