crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:07crwdne2933803:0

crwdns2933797:0Kristen Gismondicrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kristen Gismondi

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Using a heat gun, apply heat to the front of the screen for 3-5 minutes to release the glue.
-[* black] Using pry tools, pull back on the plastic blue tabs to release the digitizer and pry it back from the screen.
+[* black] Using a plastic opening tool, pull back on the plastic blue tabs to release the digitizer and pry it back from the screen.
[* black] Remove the black trim the lines perimeter of the screen and is attached to the digitizer.
-[* icon_note] This step will be very easy if a the heat gun that was mentioned previously is used.
+[* icon_note] This step will be very easy if the heat gun that was mentioned previously is used.