crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Kristen Gismondicrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kristen Gismondi

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Step two is disconnecting and removing the head lamp.
- [* black] Use a screw driver to remove the 5mm screw. Remove head lamp of drone.
+[* black] Remove the single 5 mm screw from the head lamp using a Phillips #000 screwdriver.
+[* black] Remove the head lamp from the rest of the drone.
[* red] Disconnect the electronics from the frame of the drone by pulling each arm out of the hole in the frame holding it in place.
[* icon_caution] Do not try to separate the frame from the electronics yet! Check to see if there is tape holding the head lamp wires in place underneath the electronics.