crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Dylan Gobencrwdnd2933797:0crwdne2933797:0

crwdns2936045:0crwdne2936045:0 crwdns2933505:0crwdne2933505:0 Kristen Gismondi

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Once you have unscrewed all four corners, open the device so it will be in two parts.
-[* black] As you're opening the inside of the Walkie-Talkie, don't break off any wires within the device.
-[* black] Taking the Phillips head screwdriver again, unscrew the three screws on the circuit board (green plate).
-[* black] Separate these screws from the other four since they are different sizes.
+[* black] After you have unscrewed all four corners, open the device so it will be in two parts.
+[* icon_caution] As you're opening the inside of the Walkie-Talkie, be careful not to break off any wires within the device.
+[* red] Now, taking the Phillips head screwdriver again, unscrew the three screws on the circuit board (green plate).
+[* icon_note] Make sure to separate these screws from the other four, since they are different sizes.