crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Kristen Gismondicrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kristen Gismondi

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Simply role the trigger module onto its back.
+[* black] Simply roll the trigger module onto its back.
[* red] Located on on the bottom left of the module there will be a screw with the label 3.
-[* black] Use your PH000 screw driver with bit J0. After the screw is released gently pull out the black wire.
-[* icon_note] The power chord is released from the trigger module.
+[* black] Use your a JIS 0 screwdriver. After the screw is released, gently pull out the black wire.
+[* icon_note] The power cord is released from the trigger module.