crwdns2933803:05crwdne2933803:0
crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Adjusting the trimpot on the laser | |
| [* black] ***Take a picture and mark where the original position on the laser!*** | |
| - | [* black] Adjust the laser trimpot very slightly. Depending on how harsh the failure is, the amount before it gets a 50-80% read rate will vary. |
| + | [* black] Adjust the laser trimpot very slightly. Depending on how harsh the failure is, the amount before it gets a 50-80% read rate will vary. You are going to need your Phillips PH1 bit to do this. |
| [* icon_caution] ***Do not overdo this! Adjusting it too much will wear the motor sooner then expected or burn your games!*** | |
| [* icon_note] ***I cannot tell you how much you have to adjust this. All of these fail in various ways. Some fail and only need a minor adjustment, and some need a major adjustment. Some are beyond adjustment. You will need to experiment with the laser to find the sweet spot.*** |