crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Test the printer
-[* icon_caution] Ink levels are very important for this test. Make sure your ink cartridges are at a level where capacity is not a concern. If your ink is low, the test may be impacted. Have another set of ink available just in case you need to ensure the printhead is not bad if your ink is low.
-[* icon_note] If you have a 5 color printer (K/PK/C/M/Y), you will need to print this test photo in a photo printing default mode. This is required because your printer has a second black that is not used in standard document modes.
-[* icon_note] If you have print quality problems, run a printhead cleaning to get some ink back in the system. Do not do this more then ***TWO times***. If you continue to have problems after two cleaning cycles, the printhead is likely damaged. These tend to be ~$80, so it is often cheaper to buy a new printer.
-[* black] After replacing the printhead, run a print test to see if the printer works correctly. Use the same settings as you used on the reference image and see how the printer performs after being cleaned.
+[* icon_caution] ***Ink levels are very important for this test. If any ink cartridge(s) currently installed are low, you should replace these cartridges now to make sure these results are accurate.***
+[* icon_reminder] If you have a 5 color printer (K/PK/C/M/Y), this test should be done in the photo printing mode to test Photo Black. Photo Black is not used in any other mode.
+[* icon_note] If you have any print quality problems, run a printhead cleaning to get a sufficient amount of ink back in the system. ***Tip: If you have to do this more then two times, your printhead may be damaged. These are usually ~$80, so it's typically cheaper to buy a new printer.***
+[* black] After replacing the printhead, run a print test to see if the printer works correctly. Use the same settings as you used for the reference image and compare the before and after results.