crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933805:0crwdne2933805:0

crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[title] Bypassing the first setup ink purge
+[title] Bypassing the printhead initalization
[* black] To remove the printhead from the printer, open the scanner lid, and let it come to the stopping point in the printer.
[* red] Lift the handle holding the printhead in up, as this will release the printhead.
-[* black] Lift up on the printhead, and it should be removed from the printer. Unplug the printer and leave it as found. "'DO NOT CLOSE THE PRINTER OR IT WILL RUN THE FIRST SETUP PURGE!"'
+[* black] Lift up on the printhead, and it should be removed from the printer. Unplug the printer and leave it as found. ***DO NOT CLOSE THE PRINTER OR IT WILL RUN THE PRINTHEAD INITALIZATION!***
[* icon_note] This is also a good time to check for ink on the electrical contacts, as ink tends to build up here over the years. If you see any, clean it up while you are back here.
-[* icon_reminder] ***DO NOT close the lid yet-go right to the next step as this is important to bypass the new printhead setup procedure! You also have to be somewhat quick to avoid the new printhead purge.***
+[* icon_reminder] Let me say it one more time-CLOSING THE PRINTER MAY CAUSE IT TO SEE YOU REMOVED THE PRINTHEAD