crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:05crwdne2933803:0

crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Reinstall the printhead and ink
-[* icon_caution] ***Since the calibration will be erased if the printhead errors out, wait until you are sure the prinhthead is dry before installation.***
-[* icon_caution] ***If your printer says Printhead Problem, the calibration data is gone.*** Check if the printhead is dry and installed correctly if this happens. ***WARNING:*** Since printhead initialization uses a lot of ink (~1/2 of non XL carts), it is best to use new ink cartridges.
+[* icon_caution] ***''Since the calibration will be erased if the printer errors out, wait until you are sure the prinhthead is dry before installation. Wait until you are sure it's dry to avoid problems.''***
+[* icon_caution] ***''WARNING: Printhead initialization uses ~1/2 of non-XL ink cartridges. Purchase new ink if your calibration gets erased.''***
[* icon_reminder] While the printer will not treat the printhead as "new", a ***Printhead Preparation*** process must run. This is unavoiable.
[* black] Once the printhead is satisfactorily dry, reinstall it in the printer. This is done in the reverse of how it was removed. Install your ink cartridges and plug the printer in.