crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:05crwdne2933803:0

crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Reinstall the printhead and ink
[* icon_caution] ***DO NOT plug the printer back in until the printhead and ink cartridges are replaced. If you do not install the printhead before plugging the printer in, you will erase the calibration data.***
-[* icon_caution] ***Wait until the printhead is fully dry before replacing it. It is best to wait 4-6 hours unless you plan on putting the printhead in front of a fan to dry the printhead faster.***
-[* icon_note] If your printer says ***Printhead Problem***, you did something wrong and lost your calibration data. The common cause is incorrect printhead installation. Your printer will now need to reinitialize, which will use ~1/2 of the ink in a Retail cartridge set. ***Note: If you are using used ink to initialize the printer, the printer will complain.***
-[* black] Once you have let the printhead sit long enough to fully dry, reinstall the printhead. To do this, reverse the procedure used to remove it. Plug the printer back in at this point.
-[* black] Put the ink cartridges back in once this is done. Your printer will now run a ***Printhead preperation*** step, which is unavoidable.
+[* icon_caution] ***Wait until the printhead is fully dry before reinstallation. A good general rule is to wait 4-6 hours unless you use other means to dry the printhead faster.***
+[* icon_reminder] If your printer says ***Printhead Problem***, your calibration data is erased. The most common reason is incorrect printhead installation. Reinitialzation of these printers uses a lot of ink (~1/2 of the ink in Retail cartridges), so a new set of cartridges is recommended. ***Note: While used ink can be used, these printers frequently complain.***
+[* black] Once you have let the printhead sit long enough to fully dry, reinstall the printhead. To do this, reverse the procedure used to remove it. Once the printhead is reinstalled, put the ink in next.
+[* black] Once the printhead is installed, put the ink cartridges in the printer. Once this is done, plug the printer in. ***Note:*** Your printer run a ***Printhead Preparation*** purge, which cannot be stopped.