crwdns2933805:0crwdne2933805:0
crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Adding Water to the bowl (and alcohol for stubborn clogs) | |
| - | [* black] After you remove the printhead, pour your water into a bowl if you boiled it in something other then the final bowl you were going to use. If you add Alcohol to speed this up for nastier clogs, only add a small amount. A little goes a long way. If you do use alcohol, flush it in pure water a few times to get it out before reinstallation. |
| + | [* black] After you remove the printhead, put the printhead into the bowl of water and let it sit for 30 minutes, move it around to get the flow going and replace the water as it gets cold. By the time it's cold it's probably too dirty to clean the printhead. |
| + | [* icon_reminder] Use of alcohol to fix this problem should be restricted to stubborn clogging only. If you use alcohol, flush it in clean water a few times to get it all out. |