crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:07crwdne2933803:0

crwdns2933797:0Kristen Gismondicrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kristen Gismondi

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] ***Following a few final steps, you can finally replace the side buttons. ***
-[* orange] ***Locating the Side Buttons.*** Left on the brown-colored bottom of the board, there are 2 black-and-white boxes. These are the side buttons (highlighted in red).
-[* yellow] ***Removing the Side Buttons.*** Flip the board over to reveal the green-colored side. You will see 6 silver pins. To remove the side buttons, desolder these silver pins (highlighted in orange). Once desoldered, remove the old side buttons.
-[* green] ***Replacing the Side Buttons.*** Resolder the pins of the new buttons onto the board.
-[* light_blue] ***Finishing Up***. Once you've securely soldered the new buttons to the board, reassemble your mouse. To do this, repeat Steps 1-6 in reverse.
+[* red] Left on the brown-colored bottom of the board, there are two black-and-white boxes. These are the side buttons.
+[* black] Flip the board over to reveal the green-colored side.
+[* orange] Desolder the six silver pins to disconnect the side buttons.
+[* black] Once desoldered, remove the old side buttons.
+[* icon_reminder] Resolder the pins of the new buttons onto the board.