crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Kristen Gismondicrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kristen Gismondi

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Using a Phillips J0 screwdriver, remove 6 4mm screws
-[* orange] Find the gap. Use the flat end of the spudger, slowly pry up the edge of the board.
-[* black] Move slowly in a counter-clockwise direction.
+[* red] Remove six 4 mm screws using a JIS #0 screwdriver.
+[* orange] Insert the flat end of a spudger in the gap between the motherboard and the rest of the mouse.
+[* black] Slowly pry up the edge of the board, moving around the mouse slowly in a counterclockwise direction.