crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933805:0crwdne2933805:0

crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Removing the power supply
-[* black] Remove the 4 screws from the power supply. The screw at bottom left is larger and will fit only in this hole. ***The screw marked in blue is a ground screw. This will only fit in this hole.***
-[* black] Lift the power supply up at a right angle to clear the mounting holes and start to remove it. Do not lift too much or you risk bending and damaging pins.
+[* black] Remove the 4 screws from the power supply. ***Important: The black screw is a ground screw, and will only fit in one place. Keep this screw separated from the rest of the screws. It is marked in blue.***
+[* black] Lift the power supply up at a slight angle to clear the mounting holes and start to remove it. If you lift the board out too much, you may damage the pins on the board, and potentially the video processing board.