crwdns2933803:013crwdne2933803:0
crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Remove the power supply | |
| [* icon_reminder] ***EET owners: Your kit has this bit. No purchase needed.*** | |
| [* icon_caution] ''***IF YOU ARE REPLACING THE FILTER CAPACITOR, IT MUST BE DISCHARGED BEFORE ATTEMPTING REMOVAL FOR SAFETY!***'' | |
| [* icon_caution] ***''The black screw is a ground screw and must be placed in the same location when reassembling the monitor.''*** ***The remaining 3 screws can be installed in any order when reinstalling the power supply.*** | |
| [* icon_caution] ''***Any bulged capacitors are likely to have a residual charge, and the power supply should be handed with this assumption in mind if you see any visibly bulged capacitors.***'' | |
| - | [* red] This capacitor is only found on older power supplies. ***''Replacement is |
| - | [* black] With the power supply shield removed from the monitor, identify the power supply. ***''Take note of the values, including the inverter cap (if present).''*** |
| + | [* red] This capacitor is only found on older power supplies. ***''Replacement is optional, but recommended.''*** |
| + | [* black] With the power supply shield removed from the monitor, identify the power supply. ***''Take note of the printed values, including the inverter cap (if present).''*** |
| [* black] Remove the 4 ''***Phillips #1***'' screws from the power supply. Once this is done, lift up the power supply at a slight angle to clear the chassis. ***''Do not lift too much or the connector may be damaged!''*** |