crwdns2933803:013crwdne2933803:0
crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Remove the power supply | |
| - | [* icon_caution] ***''If you see bulged capacitors, treat the power supply as if the capacitors are holding a residual charge.''*** |
| - | [* icon_caution] ***''If the filter capacitor is replaced, IT MUST BE DISCHARGED. In addition, the black screw (Blue marker) is for grounding and cannot be lost.''*** |
| - | [* icon_caution] Only lift the power supply board at a slight angle. Lifting it any higher may damage the processing board or interface. |
| - | [* icon_reminder] ***''If you cannot find the original capacitors, the original parts can be substituted.''*** |
| + | [* icon_caution] ***''If you see bulged capacitors, assume there is a residual charge.''*** |
| + | [* icon_caution] ***''If the filter capacitor is replaced, IT MUST BE DISCHARGED. In addition, the black screw (Blue) is a ground screw.''*** |
| [* red] This capacitor is only found on older power supplies. ***''Replacement is not required, but recommended.''*** | |
| [* black] With the power supply shield removed from the monitor, identify the power supply. ***''Take note of the values, including the inverter cap if present.''*** | |
| - | [* black] Remove the 4 screws from the power supply. Once this is done, lift up the power supply at a slight angle to clear the chassis. |
| + | [* black] Remove the 4 screws from the power supply. Once this is done, lift up the power supply at a slight angle to clear the chassis. ***''Do not lift too much or the connector may be damaged!''*** |