crwdns2933803:013crwdne2933803:0
crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Remove the power supply | |
| - | [* icon_caution] ***If you see bulged capacitors, |
| - | [* icon_caution] ***In most cases, the filter capacitor does NOT need to be replaced. If |
| - | [* icon_caution] ***The black screw (marked in Blue) is a ground screw. |
| + | [* icon_caution] ***If you see bulged capacitors, assume there is a residual charge. Treat the power supply accordingly.*** |
| + | [* icon_caution] ***In most cases, the filter capacitor does NOT need to be replaced. If this capacitor is replaced, it MUST be discharged.*** |
| + | [* icon_caution] ***The black screw (marked in Blue) is a ground screw and only fits in one hole. DO NOT lose this screw.*** |
| [* icon_reminder] Only lift the power supply board at a slight angle. Lifting it any more then this could result in pin or video processing board damage. | |
| [* icon_reminder] If you cannot find the original capacitors, it is okay to substitute the original capacitors with larger replacements. It is not necessary to match the capacitors used by the factory. | |
| [* red] This capacitor is only used on older power supply boards. If your board has this capacitor, replacement is recommended but is generally not required unless there is obvious bulging or leakage. | |
| [* black] With the power supply shield removed from the monitor, identify the power supply. Along with the capacitors previously mentioned, take note of any additional capacitors that were not mentioned (ex: Capacitor by the inverter coil). | |
| [* black] Remove the 4 screws from the power supply. Once this is done, lift the power supply up at a slight angle to clear the mounting holes so you can remove the power supply from the monitor. |