crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Kristen Gismondicrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kristen Gismondi

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Rotate the device so the base is facing upward.
-[* red] Using a Philips 00 screwdriver bit, remove the two 6 mm screws from the base, located at the left and right of the device QR code.
-[* orange] Using the same bit, remove the two 4 mm screws that connect the silver latch on the outside rim.
+[* red] Remove the two 6 mm screws from the base (on either side of the QR code) using a Phillips #00 screwdriver.
+[* orange] Remove the two 4 mm screws that connect the silver latch on the outside rim using a Phillips #00 screwdriver.