crwdns2933803:01crwdne2933803:0
crwdns2933797:0Tobias Isakeitcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tobias Isakeit
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Heat the feet adhesive |
|---|---|
| + | [* black] [guide|25705|Use an iOpener|new_window=true] or hair dryer to heat the adhesive underneath the feet/skates. |
| + | [* icon_note] If you’re planning to reuse the skates and just take them off to get into the mouse, note that the adhesive needs to be thoroughly heated for them to be cleanly removed. |
| + | [* red] Locate the gap in the rim around each skate. This is where to place the tool in the next step |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0