crwdns2933803:012crwdne2933803:0
crwdns2933797:0Sam Omiotekcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sam Omiotek
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* icon_caution] ***RESHOOT*** |
|---|---|
| [* black] Measuring from the center of the left microphone notch, make two marks on the adhesive strip as guides for where to cut: | |
| [* black] Make the first mark 22 mm right of the notch | |
| [* black] Make the second mark 31 mm right of the notch | |
| [* black] Measuring from the bottom edge of the strip, make a third mark in between the first two 0.16 (5/32) inches (4 mm) up from the bottom edge. | |
| [* icon_note] This cut will be very close to the top edge of the adhesive strip, but it's important that you leave material over top of the adhesive strip for proper sound isolation. When in doubt, remove less material than you think you need to. If the adhesive still covers the microphone you can always make the notch bigger. |