crwdns2933803:011crwdne2933803:0
crwdns2933797:0Dominik Schnabelrauchcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Dominik Schnabelrauch
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* icon_note] To make sure you insert the Jimmy at the correct position where the clamps are located, you can use [link|https://guide-images.cdn.ifixit.com/igi/XudhOfeVmWVwD3HJ.full|this photo]. |
|---|---|
| [* black] Insert a Jimmy into the gap between the front and back cover assembly at the inside of the right controller handle. | |
| - | [* black] Tilt the Jimmy upwards and push it into the gap between the covers at the same time to pry open the plastic clamp. You should hear a ''clack'' noise once the clamp popped open. |
| - | [* icon_note] If the clamp is completely open, the gap between the two controller covers should be about 2-3 mm wide. |
| + | [* black] Repeat the previous opening procedure to open plastic clamps at the inside of the left controller handle. |