crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:011crwdne2933803:0

crwdns2933797:0Dominik Schnabelrauchcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Dominik Schnabelrauch

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* icon_note] To make sure you insert the jimmy at the correct position where the clamps are located, you can use [link|https://guide-images.cdn.ifixit.com/igi/XudhOfeVmWVwD3HJ.full%7Cnew_window=true|this photo].
-[* black] Insert a jimmy into the gap between the front and back cover assembly at the inside of the right controller handle.
-[* black] Tilt the jimmy upwards and push it into the gap between the covers at the same time to pry open the plastic clamp. You should hear a ''clack'' noise once the clamp popped open.
+[* icon_note] To make sure you insert the Jimmy at the correct position where the clamps are located, you can use [link|https://guide-images.cdn.ifixit.com/igi/XudhOfeVmWVwD3HJ.full|this photo].
+[* black] Insert a Jimmy into the gap between the front and back cover assembly at the inside of the right controller handle.
+[* black] Tilt the Jimmy upwards and push it into the gap between the covers at the same time to pry open the plastic clamp. You should hear a ''clack'' noise once the clamp popped open.
[* icon_note] If the clamp is completely open, the gap between the two controller covers should be about 2-3 mm wide.