crwdns2933803:013crwdne2933803:0
crwdns2933797:0Sam Omiotekcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sam Omiotek
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove any remaining bearings |
|---|---|
| + | [* icon_note] There may be one or both bearings left in the gearbox case. Follow these steps to remove any remaining bearings: |
| + | [* icon_caution] A torch is necessary. Wear protective eyewear and heat resistant gloves. Move to a well ventilated area away from anything flammable. |
| + | [* black] Use a torch to heat the outside of the casing near the bearings. |
| + | [* icon_note] The bearings may fall out on their own as the casing expands. |
| + | [* black] Tap the outside of the gearbox case with a hammer to knock the bearings out. |
| + | [* black] If the bearings don't fall out, reheat the casing and try again. If they remain stuck, flip over the gearbox case and use a flathead screwdriver to pry the bearings out. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0