crwdns2933803:012crwdne2933803:0
crwdns2933797:0Sam Omiotekcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sam Omiotek
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Use a pair of pry bars to break the second gear and pinion gear loose from the gearbox case. | |
| [* black] Once loose, remove the gear and pinion gear by hand. | |
| - | [* black] Use |
| - | [* icon_note] If the bearings are stuck, heat the outside of the case behind the bearing with a torch. |
| - | [* icon_caution] |
| - | [* icon_reminder] Before reassembly, wipe out as much of the old grease as possible and add plenty of new grease. |
| + | [* black] Use a pry bar or internal jaw puller to remove the remaining two bearings from the case. |
| + | [* icon_note] If the bearings are stuck, heat the outside of the case behind the bearing with a torch and try again. |
| + | [* icon_caution] Wear gloves and protective eyewear when working with a torch. |
| + | [* icon_reminder] Before reassembly, wipe out as much of the old grease as possible and add plenty of new grease to each new component as you install them. |