crwdns2933803:01crwdne2933803:0
crwdns2933797:0Troycrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sam Omiotek
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Remove existing bezel | |
| - | [* icon_caution] Always power down your |
| + | [* icon_caution] Always power down your device before attempting any repair. |
| [* black] This is the only stressful part of the repair but is surprisingly easier than it seems. | |
| [* black] You need to remove the existing cracked bezel. Use a hairdryer to carefully loosen the adhesive. | |
| [* black] NOTE: The adhesive is a 4mm strip of double-sided tape it is only on the top side of the bezel. Be extra careful if you are using a hairdryer or heatgun. | |
| [* black] You may not need to use heat to loosen the adhesive, I myself simply used a tweezer to pick off bits of glass, I was able to slowly take one side off. Then simply running my nail down the other half the whole bezel came off in one go |