crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:07crwdne2933803:0

crwdns2933797:0Sam Omiotekcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sam Omiotek

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

+[title] Remove the right arbor shaft bearing
[* red] Use a 1/8 inch hex key to loosen the two set screws on the arbor shaft bearing next to the blade backing plate.
- [* icon_reminder] During reassembly, do not tighten the set screws until the bearings have been secured to the frame (see step 20) to ensure proper alignment.
+ [* icon_reminder] During reassembly, do not tighten these set screws until the bearings have been secured to the frame to ensure proper alignment.