crwdns2933803:02crwdne2933803:0
crwdns2933797:0Sam Omiotekcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sam Omiotek
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Use a universal puller to remove the pulley from the cutter wheel shaft: |
|---|---|
| + | [* black] Attach the universal puller to the pulley using the three bolts provided on the pulley. |
| + | [* black] Use a wrench to torque down the center screw to slowly loosen the pulley. |
| + | [* icon_note] This may take a lot of force. |
| + | [* icon_note] If the pulley seems to be stuck after significant pressure is applied with the universal puller, use a blowtorch to apply heat where the pulley contacts the shaft. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0