crwdns2933803:03crwdne2933803:0
crwdns2933797:0Sam Omiotekcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sam Omiotek
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* yellow] Wrap a piece of tape around the upper half of the tensioner bolt to mark the location of the second nut. |
|---|---|
| + | [* green] Use a 9/16 inch wrench to loosen the nut on the lower half of the tensioner bolt until the motor can slide forward as much as possible. |
| + | [* icon_reminder] During reassembly, reference the tape to position the outer nut into the same location as before to ensure proper belt tension. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0