crwdns2933803:08crwdne2933803:0
crwdns2933797:0Dominik Schnabelrauchcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Dominik Schnabelrauch
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Place the watch on a flat surface and make sure all the display adhesive is loose. |
|---|---|
| + | [* icon_caution] If possible avoid working with the opening pick at the edge where the watch crown is located to prevent damaging the display cables. For the case you need to cut the adhesive on this edge don't insert the opening pick deeper than 1/16th of an inch (~2 mm). |
| + | [* black] Slide an opening pick under opposite display edge of the watch crown. |
| + | [* black] Tilt the opening pick to pry the display off the watch case. |
| + | [* icon_caution] Don't try to remove the display. It is still connected to the watch assembly. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0