crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:07crwdne2933803:0

crwdns2933797:0Sam Omiotekcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sam Omiotek

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Insert an opening pick into the lower-left corner of the rear panel.
[* black] Using another opening pick, cut the adhesive along the left edge of the rear panel.
-[* icon_caution] Do not insert an opening pick in too far or internal components could be damaged, especially around the camera and fingerprint sensor.
-[* icon_note] It is fine if opening picks fall out as the back cover becomes seaprated.
+[* icon_caution] Do not insert an opening pick in more than half way on the left edge near the fingerprint sensor or you may damage the ribbon cable inside.
+[* icon_note] It is fine if opening picks fall out as the back cover becomes separated.