crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:07crwdne2933803:0

crwdns2933797:0Dominik Schnabelrauchcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Dominik Schnabelrauch

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* icon_note] If the phone's screen is cracked, the suction cup may not stick. Try [https://d3nevzfk7ii3be.cloudfront.net/igi/4MmKE22Cy2MavVZU|lifting it with strong tape|new_window=true], or superglue the suction cup in place and allow it to cure so you can proceed.
-[* icon_caution] While cutting, make sure the pick slides ***under the display panel ***and not just between the display and the front glass.
+[* black] Once the screen is warm to the touch, apply a suction cup near the top edge of the phone right under the earpiece speaker.
+ [* icon_note] If the phone's screen is cracked, the suction cup may not stick. Try [https://d3nevzfk7ii3be.cloudfront.net/igi/4MmKE22Cy2MavVZU|lifting it with strong tape|new_window=true], or superglue the suction cup in place and allow it to cure so you can proceed.
[* black] Pull up the suction cup to create a gap between the screen and the display bezel.
-[* black] Insert the tip of an opening pick in the gap you created and slide it to the bottom right corner.
- [* icon_note] Mind the plastic tabs mentioned before.
+[* black] Insert the tip of an opening pick in the gap you created and slide it to top right corner of the phone. Leaf it there to prevent the adhesive from resealing.