crwdns2933803:09crwdne2933803:0
crwdns2933797:0Dominik Schnabelrauchcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Dominik Schnabelrauch
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* icon_caution] In the following steps you'll be very carefully prying up the logic board. The place to lift it is very tight. Avoid damage to the left and right interconnect and antenna cables, by making sure they don't get caught by the logic board when prying it up. |
|---|---|
| + | [* black] Insert the flat end of a spudger between the logic board and the rear case of the iPad. |
| + | [* black] Use the spudger to slowly pry up the right side of the logic board. |
| + | [* icon_note] If the adhesive is too strong to pry up the logic board, apply the [guide|25705|heated iOpener|new_window=true] another time to loosen the adhesive beneath. |
| + | [* black] Pry up the left side of the logic board until you can get a good grip. |
| + | [* icon_caution] Don't try to remove the logic board all the way! It is still connected to the bottom area of the iPad. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0