crwdns2933805:0crwdne2933805:0
crwdns2933797:0Dominik Schnabelrauchcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Dominik Schnabelrauch
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* icon_caution] In the following steps you'll be prying up the logic board. The place to lift the logic board is very tight. Avoid damage to the left and right interconnect and antenna cables. | |
| [* black] Insert the flat end of a spudger between the logic board and the rear case of the iPad. | |
| [* black] Use the spudger to pry up the right side of the logic board. | |
| [* icon_note] If the adhesive is too strong to pry up the logic board, apply the [guide|25705|heated iOpener|new_window=true] another time to loosen the adhesive beneath. | |
| [* black] Pry up the left side of the logic board until you can get a good grip. | |
| + | [* icon_caution] Don't try to remove the logic board all the way! It is still connected to the bottom area of the iPad. |