crwdns2933803:02crwdne2933803:0
crwdns2933797:0Dominik Schnabelrauchcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Dominik Schnabelrauch
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Insert wisdom here. |
|---|---|
| + | [* black] Place a suction cup next to the iPad's home button and press down to create a seal. |
| + | [* icon_note] To get the most leverage, place the suction cup as close to the edge as possible without going past the edge of the display. |
| + | [* black] Firmly pull up on the suction cup to to create a small gap between the front panel and the rear case. |
| + | [* icon_caution] Do not pull too hard or you may shatter the glass. |
| + | [* black] Once you've opened a sufficient gap, insert an opening pick into the gap to prevent the adhesive from resealing. |
| + | [* black] Slide the pick along the edge of the display, towards the bottom left corner and leave it there to prevent the adhesive from resealing. |