crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Kristen Gismondicrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kristen Gismondi

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Set Multimeter to VDC, and place leads as shown.
-[* black] Voltage should be about 5V.
-[* black] If the voltage is lower, check output of the power supply. If the power supply voltage is above 6V, then we will need to continue to Step 4.
+[* black] Set the multimeter to VDC, and place the leads as shown.
+[* icon_note] The voltage should be about 5V.
+[* icon_note] If the voltage is lower, check the output of the power supply. If the power supply voltage is above 6V, then we will need to continue to Step 4.