crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Kristen Gismondicrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kristen Gismondi

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Use the same screwdriver and PH1 bit from Step 1 to unscrew the two 9.0 mm screws on the circuit board that corresponds to the red power button.
-[* icon_caution] Remove gently, circuit board is connected by wire to the console. Removing cable from console case may allow more slack.
-[* icon_reminder] Spring may be under compression, don't lose it.
+[* red] Use a PH1 screwdriver to unscrew the two 9.0 mm screws on the circuit board that corresponds to the red power button.
+[* icon_caution] Remove gently. The circuit board is connected by wire to the console. Removing the cable from the console case may allow more slack.
+[* icon_note] A spring may pop out.