crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Tobias Isakeitcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tobias Isakeit

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Use a curved blade to get in between the thin gap between the display and the body.
-[* black] Place the curved section of the blade in the gap between the glass and case on the top edge of the watch face, and press down into the gap.
+[* icon_caution] Always keep your fingers completely clear of the knife, and be careful not to apply too much pressure, as this might cause the knife to slip and cut you, or damage the watch.
+[* black] Use a curved blade to get in between the thin gap between the display and the body (short side of the display closest to the digital crown.
[* black] When the thin part of the blade went into the gap, tilt the blade towards you to widen the gap and lift the display slightly open.
-[* icon_caution] Always keep your fingers completely clear of the knife, and be careful not to apply too much pressure, as this might cause the knife to slip and cut you, or damage the watch.
+ [* icon_caution] Do not insert the knife more than 1/16 of an inch (2 mm).