crwdns2933803:02crwdne2933803:0
crwdns2933797:0Tobias Isakeitcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tobias Isakeit
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Use a suction handle to lift the back cover and an opening pick to get in the gap. | |
| [* icon_note] Since the back is also slightly curved at the edges you want to insert the opening pick in an angle from underneath. | |
| [* black] Start at the middle of the side and cut the adhesive in a constant movement while pulling with the suction handle. | |
| [* icon_caution] Be careful not to lever the opening pick too much to avoid breaking the back cover. Rather pull with the suction handle and use the pick for cutting the adhesive. | |
| [* black] Move the pick toward the bottom and the top to separate adhesive. | |
| + | [* black] If it's getting harder to move the pick you might need to reheat the iOpener and apply it to the back cover. |
| [* black] Leave the pick near the top corner. |