crwdns2933803:02crwdne2933803:0
crwdns2933797:0Tobias Isakeitcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tobias Isakeit
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Use a suction handle to lift the back cover and an opening pick to get in the gap. |
|---|---|
| + | [* icon_note] Since the back cover is also slightly curved at the edges you want to insert the opening pick at a lower angle from underneath. |
| + | [* black] Start at the middle of the side and cut the adhesive while pulling up with the suction handle. |
| + | [* icon_caution] Be careful not to lever the opening pick too much to avoid breaking the back cover. Rather pull with the suction handle and use the pick for cutting the adhesive. |
| + | [* black] Move the pick toward the bottom corner and leave it there to keep the adhesive from reattaching to the case. |
| + | [* black] Use another pick and move the top corner. |
| + | [* icon_note] If it's getting harder to move the pick you might need to reheat the iOpener and apply it to the back cover. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0