crwdns2933805:0crwdne2933805:0
crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Glue the magnets down | |
| [* icon_caution] You only have 1 shot at this. If you glue it in the wrong position, you may need a new controller frame. | |
| [* black] With the position known, open the tape so you can access the magnet. With the back of the magnet exposed, put a drop of glue on the back of the magnet. cut the tape to allow motion of the magnet. Leave the tape in place for 30-60 seconds so the glue can cure. | |
| - | [* black] Once the glue is cured, allow the controller to sit |
| + | [* black] Once the glue is cured, allow the controller to sit disassembled for 24 hours. This will help ensure the glue is properly cured. |