crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933805:0crwdne2933805:0

crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Glue the magnets down
-[* icon_caution] You only have 1 shot at this. If you glue it in the wrong position, you will need to sand the plastic and magnet and start over.
-[* black] With the position known, cut the tape to allow motion of the magnet. Once you have motion, use Super Glue to hold the magnet in place. Hold the magnet until it is dry enough to stay (30-60 seconds).
-[* black] Tape the magnet back in place and let the glue dry for 24 hours.
+[* icon_caution] You only have 1 shot at this. If you glue it in the wrong position, you may need a new controller frame.
+[* black] With the position known, open the tape so you can access the magnet. With the back of the magnet exposed, put a drop of glue on the back of the magnet. cut the tape to allow motion of the magnet. Leave the tape in place for 30-60 seconds so the glue can cure.
+[* black] Once the glue is cured, allow the controller to sit disassembled for 24 hours. This will help ensure the glue is properly cured.