crwdns2933803:06crwdne2933803:0
crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Align the magnet and glue it in place | |
| [* icon_caution] ***You only have 1 shot at this. If you glue it in the wrong position, you may need a new controller frame.*** | |
| - | [* icon_note] If both triggers are affected, repair |
| + | [* icon_note] If both triggers are affected, repair each trigger individually. Do not repair both at once. |
| [* icon_reminder] If the reason you are doing this repair is related to games self pressing the trigger, realign the magenets to fix this ***before*** gluing them into the frame. In this scenario, I am replacing the worn out double sided tape used at the factory. | |
| - | [* black] After the magnets are removed, line up your marking that was made to figure out where the magnets were installed at the factory when the controller was new. ***Once you align the marks correctly, tape the magnets down to keep them in place for when they are glued in.*** |
| - | [* black] Once you know where the magnet goes, glue the magnet to the trigger. Let the glue dry for 24 hours before continuing. ***Note: If the glue you are using does not call for this, it may be possible to cut this time down.*** |
| - | [* black] Repeat this procedure for the other trigger if both are affected. |
| + | [* black] After taping the magnet(s) down in the previous step, verify the alignment is correct one more time. ***After verifying the alignment is correct***, glue the magnet(s) to the controller frame. |
| + | [* black] Once the magnets are glued in, let them dry for 24 hours before finishing the repair. ***Note: It may be possible to cut this time down if the glue you used cures in less time.*** |