crwdns2933803:06crwdne2933803:0
crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [title] Find the correct position and glue the magnet down |
|---|---|
| - | [* icon_caution] ***You only have 1 shot at this. If you glue it in the wrong position, you may need a new controller frame.*** |
| - | [* icon_note] If both triggers are affected, repair one at a time. Do not do both at once. |
| - | [* icon_reminder] If the reason you are doing this repair is related to games self pressing the trigger, tape the magnets down and find the best position that does not cause that problem. I am doing it on this controller because the factory tape is beginning to fail. |
| - | [* black] After the magnets are removed, line up your marking that was made to figure out where the magnets were factory installed. Once you find the mark, tape the magnets down to prepare for glue. |
| - | [* black] Once you know where the magnet goes, glue the magnet to the trigger. Let the glue dry for 24 hours before continuing. ***Note: If the glue you are using does not call for this, it may be possible to cut this time down.*** |
| - | [* black] Repeat this procedure for the other trigger if both are affected. |
| + | [title] Align the magnet and glue it in place |
| + | [* icon_caution] ***You only have 1 shot at this. If you glue it in the wrong position, you may need a new controller frame. If both triggers have a problem, repair each trigger individually; do not do both at the same time.*** |
| + | [* icon_reminder] If the reason you are doing this repair is related to games self pressing the trigger, realign the magenets to fix this ***before*** gluing them into the frame. In this scenario, I am replacing the worn out double sided tape used at the factory. |
| + | [* black] After taping the magnet(s) down in the previous step, verify the alignment is correct one more time. ***After verifying the alignment is correct***, glue the magnet(s) to the controller frame. |
| + | [* black] Once the magnets are glued in, let them dry for 24 hours before finishing the repair. ***Note: It may be possible to cut this time down if the glue you used cures in less time.*** |