crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Put tape on the magnets and find the best position
[* icon_note] Do this one trigger at a time. Do not do both at once.
-[* black] Put tape on the magnets and find out where the controller triggers the magnets persistently so you know the point you will have more problems. Once you do this, mark the point where the magnets do not cause this behavior.
-[* black] Once you find a position that works every time and does not trigger the problem, tape the magnets down in that position and test it for repetition. If it no longer happens, keep the tape there so you know where to glue it later.
+[* black] Put tape on the magnets and find out where the controller triggers the magnets without you touching it. Once you know what this point is mark it on the trigger.
+[* black] Once you find a position that works every time and does not trigger the problem, tape the magnets down in that position and test it for repetition. It should not press itself but also trigger something when pressed halfway down. Once you find this point, mark it so you know where to glue the magnet.
[* black] Repeat this procedure for the other trigger if both are affected.