crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:05crwdne2933803:0

crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Clean up the magnet(s)
-[* icon_caution] ***Correct magnet alignment is critical. Misalignment of the magnet may result in the controller pressing the LT/RT buttons without any human input.***
+[* icon_caution] ***Correct magnet alignment is critical. Misalignment of the magnet may result in LT/RT activation without human input.***
[* icon_note] You do not need to clean 100% of the tape residue. Clean as much as you can.
-[* red] After cutting the heatshrink tubing, align the marks made in the previous step to get an idea of what to do when you glue the magnets in place.
-[* orange] These controllers use double sided tape from the factory. Note the dimple side after removal and clean the magnet and frame. ***If you cannot clean the glue with alcohol, use [https://www.amazon.com/dp/B00006IBNJ/|Goo Gone].***
-[* yellow] Once the magnet(s) are reasonably clean, practice aligning the lines until you're comfortable. Once the alignment is correct, tape the magnets to ensure a correct alignment once glue is applied.
+[* red] After cutting the heatshrink tubing, do a practice alignment to have an idea for final magnet placement.
+[* orange] These controllers use double sided tape from the factory. Note the dimple side and clean the magnet and frame. ***If the residue is difficult to clean, use [https://www.amazon.com/dp/B00006IBNJ/|Goo Gone].***
+[* yellow] Once the magnet(s) are reasonably clean, do one final alignment. Once you are confident it is right, apply tape to aid in final installation.