crwdns2933803:05crwdne2933803:0
crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Clean up the magnet(s) | |
| [* icon_caution] ***Correct magnet alignment is critical. Misalignment of the magnet may result in the controller pressing the LT/RT buttons without any human input.*** | |
| - | [* icon_ |
| + | [* icon_note] You do not need to clean 100% of the tape residue. Clean as much as you can. |
| [* red] After cutting the heatshrink tubing, align the marks made in the previous step to get an idea of what to do when you glue the magnets in place. | |
| [* orange] These controllers use double sided tape from the factory. Note the dimple side after removal and clean the magnet and frame. ***If you cannot clean the glue with alcohol, use [https://www.amazon.com/dp/B00006IBNJ/|Goo Gone].*** | |
| [* yellow] Once the magnet(s) are reasonably clean, practice aligning the lines until you're comfortable. Once the alignment is correct, tape the magnets to ensure a correct alignment once glue is applied. |