crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:05crwdne2933803:0

crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Clean up the magnet(s)
[* icon_caution] ***Correct magnet alignment is critical. Misalignment of the magnet may result in the controller pressing the LT/RT buttons without any human input.***
-[* icon_reminder] Clean as much tape residue as you can. This does not need to be 100% clean.
+[* icon_reminder] You do not need to clean 100% of the tape residue left behind. It just needs to be mostly clean.
[* red] After cutting the heatshrink tubing, align the marks made in the previous step. ***Before applying glue, practice how you will align it so you do not get it wrong.***
-[* orange] From the factory, these controllers use double sided tape. Remove the magnet noting the way the dimple is visble and clean as much of the glue as you can. ***If you cannot get it off with alcohol, a solvent like [https://www.amazon.com/dp/B00006IBNJ/ref=sspa_mw_detail_0?psc=1|Goo Gone] can be used.***
-[* yellow] Once the magnet(s) are reasonably clean, line the alignment marks up with the frame. Once the alignment is correct, tape the magnets to ensure a correct alignment once glued in place.
+[* orange] From the factory, these controllers use double sided tape. Remove the magnet noting if the dimple is visible and clean the tape residue. ***If you cannot get it off with alcohol, a solvent like [https://www.amazon.com/dp/B00006IBNJ/ref=sspa_mw_detail_0?psc=1|Goo Gone] can be used.***
+[* yellow] Once the magnet(s) are reasonably clean, line the alignment marks up with the frame. Once the alignment is correct, tape the magnets to ensure a correct alignment once glue is applied.